Chev Beretta Car Answers1991 Beretta Ignition System Malfunctionthe second plug on front bank has no spark. I have replaced the wire and ignition moduaelGet Answers About Your Chev Beretta1995 Beretta General Malfunction95 Baretta PCV valve causing the engine to stall.3.1 L, A/C, AUTO, in Michigan Service engine soon lamp on. Checked the PCV valve and it had a light brown sluge buildup on it. Replaced it and the engine stalls out right away. Engine runs fine without being hooked up to it. Can't get any codes because of the wierd plug under the steering wheel. AutoZone tried to get codes but could not. WHAT CAN I DO NEXT 1989 Beretta Engine OtherAfter rebuilding the engine on the 1989 2.8 V6. I ran in to trouble. I replaced the ECM and the ignition control module. STILL NO PULSE FROM THE ECM TO GROUND THE INJECTORS. Finished today tapping into wires to check volts and grounds. Ecm main ground is good, all hi and low volts are correct from ignition module to ECM, Just NO PULSE FROM ECM TO INJECTORS. FUEL pressure is good and the injectors all have correct volt. WHAT CAN BE WRONG WITH THIS SYSTEM, ARE THE INJECTORS L JUST BAD. BECAUSE I'M NOT HEARING NO CLICKING AT L. JUST NO GROUND FROM ECM.1989 Beretta Engine Won't StartAfter rebuilding the engine on my 89 beretta, I was unsuccessfull at many attemts to start her. I had spun a rod a few years ago and was still driving around before parking in the back yard. Replaced many parts inclueding crankshaft, rings, one rod and new bearings. All went well until i tried to start and rediognous a new problem. First no fuel pump, then hot wire the oil presure sensor to activate pump.also tested with hot lead above driverside shock tower. All other wire were properly hooked up. All fuses were check and double checked.Inside and out but "no injector was releasing any fuel. There was also good fuel presure and spark from coils. Tested self-diognostic no change in any thing, still 12. ONly then started guessing maybe crankshaft or sensor, so replaced the sensor. Maybe computer. PLEASE HELP her run strong again. 2.8 1989. please tell me something I don't know. OR maybe proper vin number for crankshaft. I order by make model and year, but i dont know what else to do. |
||
Quick ListHome |
AnswersHome |
|
|
|
